The procedure of garage door opener installation is typically uncomplicated, though makers and components might vary. Because these openers are usually installed by the customer, installation directions are clear. A well-reputed company such as Ace Garage Door Fort Worth can also help you do a perfect opener installation.

This process should just take a very little amount of time and your opener will be completely operational.

Assemble the Opener

Outline all parts as the instructions indicate. Components are generally marked or might include lettered sticker labels. The first step is to put together the rail. Next, you will connect it to the opener’s electric motorhead. When the opener has been totally put together, the last step is installation.

Connect the Rail to the Header

 

To execute this step, you will need an 8-foot ladder. Elevate your garage and mark it at the acme. Shut the garage door.

At the website of the mark, measure up 2 inches. The bottom of the header brace will certainly be positioned right here, over the facility of the door. Location the header bracket on at the second mark and protect it with two wooden lag bolts.

With the electric motor upright the floor and the rail inside the header bracket, line up the opener setting up on the door. You will certainly need to line up the holes on the rail with the header bracket. Glide a clevis pin with the bracket and rail to attach.

Mount the Motor

Place the ladder at the back of the door tracks, in the center. An area the motor on the ladder. Slowly, elevate the garage door till it can be found in contact with the door. As you continue to open the door, the electric motor setting up will be taken off the motor. When the door is totally open, put a 2×4 between the opener rail and the door.

To do your garage door opener installation proper, you will certainly have to attach the wall mounts to the electric Motorhead into the ceiling packs. Making use of the guidelines and hangers given, attach them to the ceiling with lag bolts. After attaching the hangers, lift the motor head and bolt it to the ceiling wall mounts.

 

Leave a Reply

Your email address will not be published. Required fields are marked *